Steps to change the password on a Cisco Switch
By Nabil Nawaz, Viscosity NA.
These steps were used to change the password on a Cisco Switch on Exadata X2.
Telnet to cisco switch(IP Address of Switch)
$ telnet
• Enable command line for switch
telnet> enable
• Prepare to configure switch
ciscoswitch-ip# configure terminal
exapsw-ip(config)#line vty 0 15
exapsw-ip(config-line)#login
• Change the password
exapsw-ip(config-line)#password newpassword
exapsw-ip(config-line)#login
exapsw-ip(config-line)#end
• Save the changes to the switch
exapsw-ip#write memory
Building configuration…
Compressed configuration from 4001 bytes to 1608 bytes[OK]
exapsw-ip#
• Try logging again to verify password change
Comments are closed